• 0 رای - 0 میانگین
  • 1
  • 2
  • 3
  • 4
  • 5
How can I configure PROFIsafe telegrams (message frames) for SINAMICS G120x frequency
#1
Description
When configuring PROFIsafe telegrams (message frames) for SINAMICS G120x converters (e.g. G120 with Control Units CU2xy-2 from FW4.5, or G120C PN from FW4.5) with PROFINET interface in the HW Config of STEP 7 using the Drive ES Basic software, the following minimum prerequisites must be fulfilled for the software:
Minimum prerequisites
•STEP7 from V5.5 SP1
•Drive ES Basic from V5.4 and higher
•STARTER from V4.3 SP1
•S7 Distributed Safety programming from V5.4 SP5 and higher
•S7 F Configuration Pack from V5.5 SP9 and higher
Procedure
When inserting a PROFIsafe telegram (message frame) in the HW Config, please proceed as follows:


Nr. Instruction
1 Select the configured converter
2 Double-click on the "Antriebsobjekt [Drive object]" slot in the lower section of HW Config
[عکس: G120-CUxx-PN_PROFIsafe_and_DriveES_01_en.jpg]
Picture 01

3 Go to the next dialog "Properties" under the "Options" tab
4 Select the required PROFIsafe telegram (message frame) (e.g. PROFIsafe message frame 30 or 900)
5 Acknowledge with "OK"
[عکس: G120-CUxx-PN_PROFIsafe_and_DriveES_02_en.jpg]
Picture 03

6 Then save and compile HW Config, by pressing the corresponding[عکس: icon01.jpg]button.
Note
Links to the software packages available online that can be downloaded:
•Service Pack 2 for STEP 7 V5.5 and STEP 7 Professional 2010; Entry-ID: 57026339
Note:
When installing the software packages, observe the sequence required!
If STEP 7 and/or Drive ES Basic is installed or must be upgraded, then the STARTER software must be newly installed or installed again!
•STARTER software; Entry-ID: 26233208
•S7 Distributed Safety V5.4 + SP5; Entry-ID: 37592670
•F Configuration Pack V5.5 + SP9 Update 1; Entry-ID: 15208817
Other software packages required, will be charged for and/or must be licensed and therefore are not available for download.
Security Notice
Caution
The functions and solutions described in this article confine themselves to the realization of the automation task predominantly. Please take into account furthermore that corresponding protective measures have to be taken up in the context of Industrial Security when connecting your equipment to other parts of the plant, the enterprise network or the Internet. Further information can be found under the Entry-ID 50203404.
پاسخ


Digg   Delicious   Reddit   Facebook   Twitter   StumbleUpon  


کاربران در حال بازدید این موضوع:
1 مهمان


کلیه حقوق این وب سایت محفوظ و متعلق به قشم ولتاژ می باشد. طراحی و اجرا توسط